This is a set including a smartphone holder from Daiso. Since there isn't a good place to mount a smartphone holder in an Every, I created a mount using a 3D printer. I fixed the spherical part taken from the Daiso smartphone holder to this mount, and then attached a smartphone holder (with the spherical part removed) that I prepared separately. The spherical part in the first photo is the part taken from the Daiso holder. Things to check before purchasing: The diameter of the spherical part of the Daiso holder is approximately 17mm. I saw in an online article that the size of this part is generally the same for most holders. However, please confirm that the diameter of the spherical part of the holder you will use is the same before purchasing. Features: Slightly away from the air conditioning vent. Two mounting points on the mount (top and bottom). Easy operation. Does not overlap with the steering wheel. Drink holder can be used. Small item storage can be used (to some extent). Does not touch the turn signal when operating. Total sales: 58 units by the end of September (including those without the Daiso holder) Product contents: Mount: 1 piece, made of ABS Daiso smartphone holder: E-SPH-1, 1 piece (unopened) Items needed other than the product: Smartphone holder for mounting Double-sided tape, 0.8mm thick, high-temperature type for car interiors About installation: The Daiso holder has a rubber covering the metal part, which can be removed with a flathead screwdriver, but it's easier to cut it off with nippers. The tapping screws for the spherical part are short, so if you are concerned about securing it to the mount, consider using adhesive as well. The mount may peel off if only the wall part is used, so be sure to apply double-sided tape to the U-shaped part of the mount as well. Please be very careful not to get injured when disassembling the Daiso holder. Notes: Since it is created with a layered 3D printer, there are layer lines and scratches. There is no guarantee if the combination of the mount, Daiso holder, and the holder you use is not correct. There is no warranty for this product, nor for any defects that may occur due to the use of this product. Thank you.