① SUREFIRE G3 BK (P90 Xenon Bulb / 200 lumens) ② NEXTORCH FR-1 Ring (G-series tail cap specific modification) ③ NEXTORCH BFTC Blue Light Twist Tail Cap This is a set sale. ・The G3 body has scratches, but no noticeable dents or damage. The lens has been replaced with a low-reflection glass lens. There is no play in the tail cap unit. There is almost no wear on the rubber boot. ※The xenon bulb is a consumable item, so the remaining lifespan and possible operating time cannot be guaranteed. ・The FR-1 has scratches from modification. It has been modified specifically for G-series tail caps, which are wider in diameter than P-series. After the entire inner circumference has been shaved down, a groove has been carved to allow the tail cap's protrusion to pass through. It can be constantly illuminated without interfering with the logo with a 1/8 turn from the momentary-on position. When attaching or removing the tail cap, lifting the tip of the ring will prevent it from contacting the body. ・The BFTC is an unused item that has been stored. It has four bullet-shaped blue LEDs, and 2-3 lights are always visible from the side. It is bright enough to be used as a marker. There are constant-on and flashing patterns. The flashing cycle is about 0.8-0.9 seconds. Comes with packaging. Operation ① Off → Tighten to illuminate the tail light → Tighten further to illuminate the xenon bulb → Loosen to flash the tail light → Loosen to turn off. Operation ② Off → Tighten to illuminate the tail light → Loosen once and tighten to flash the tail light. ※It requires some force to turn on the G-series body. (Requires both hands) ※Compatible voltage is up to 9V. ※It will not function or illuminate properly with P60 series LED modules. Batteries are not included. Please refrain from purchasing if you are sensitive or particular about details. No pets. Non-smoking. Shipped via Yu-Packet Plus. Shipping cost of 520 yen included.