This is a set of tools for the practical exam of the Class 2 Electrician's License. It was used for the second half of the 2024 exam. * Circuit breaker x 1 * Outlet box x 1 * Box connector for non-threaded conduit x 2. The threads have been cut. Before the actual exam, it's a good idea to buy some that haven't been threaded and practice cutting the threads. They can be purchased for a few dozen yen. * Lamp receptacle x 1 * Hanging ceiling fixture (square) x 1 * Hanging ceiling fixture (round) x 1 * Flush-mount multiple switch frame x 5 * Flush-mount multiple switch frame (plastic) x 1. This isn't used in the actual exam, but the metal ones break after about five uses, so use the plastic ones for practice. * Outlet (flush-mount) x 1 * Insulating bushing x 1 * Terminal block 6P x 1 * Terminal block 3P x 1 * 3-way switch (flush-mount) x 2 * Position indicator light built-in switch (flush-mount) x 1 * Single-pole switch (flush-mount) x 2 * PF tube box connector x 2 * Outlet (surface-mount) x 1 * 4-way switch (flush-mount) x 1 * Grounding outlet (flush-mount) x 1 * Grounding outlet 20A 250V x 1 * Pilot lamp (flush-mount) x 1 * Rubber bushing for 19 (pre-drilled) x 4 * Rubber bushing for 19 (undrilled) x 3 * Rubber bushing for 25 (pre-drilled) x 4. You can make holes in the rubber bushings with nippers, so it's not a problem if you practice once. * Push-in connector for 2 wires (red) x 5 * Push-in connector for 3 wires (blue) x 2 * Push-in connector for 4 wires (yellow) x 2 * Non-threaded metal conduit x 1 * Flexible plastic conduit (PF tube) x 1 * Grounding terminal with grounding terminal outlet x 1 * Pass clips x 5 * Ring sleeves (small, medium). I haven't counted them, but I think there are enough to do the tasks about twice. The only missing tools are: * Double outlet * Grounding outlet (flush-mount), but the flush-mount outlet can be substituted for the double outlet. After taking the pictures, I also found a HOZAN cloth tape measure, so I will ship it together.