This is a used item in player's condition. Please read the following description carefully and purchase with your understanding. I purchased this used around 2008, and the warranty card and other documentation are not available, so the detailed specifications are unknown. This is a DIY-repaired item by the seller and previous owner, so please consider it as junk and no returns or claims will be accepted. Neck: 3-piece through-neck (probably maple) There are no visible warps or twists in the neck. The truss rod works in both directions. Fingerboard: Probably ebony Scale: 648mm Radius: Unknown Frets: 24F There is little wear, with more than 80% remaining. Top: Flame maple The top material is thick and solid. Back: Mahogany-like. Bridge: German-made Floyd Rose Original Some parts of the insert block are stiff, but you can move them with a flathead screwdriver to change strings. There are no operational problems. An arm bar is also included. The back springs may not be genuine. The back panel is not included. Pickup (Front): Seymour Duncan SH-1n '59 model Modified with 4-conductor shielded wire for coil tapping. (Currently, the tap wiring is not connected.) Pickup (Bridge): Seymour Duncan TB-4 JB model It appears to have been direct-mounted once, and the screw holes are enlarged. To reattach it with an escutcheon, M2.6 nuts have been attached with adhesive. Assembly: 1 Volume, 1 Tone, 3-way PU selector For the listing, the control pots, PU selector, and output jack have been replaced with new SCUD brand parts. Naturally, there is no scratchiness, and the sound output is good. Belden wiring is used internally, and the tone circuit capacitor is an Orange Drop 0.22μF. There are a few small scratches and dents, but they are not very noticeable. I think they are hardly noticeable from a distance. An ESP hard case is included. It is not in very good condition, so please consider it as an extra.