Compatible Vehicle Manufacturers: Toyota, specifically for the new Sienta! Type of Parts: Side molding emblems & rear & front emblems Material: Acrylic resin (Banana Yellow) These are side molding accessories specifically for the Toyota new Sienta. They are custom-made using laser processing. These dress-up parts are installed on the recessed areas of the Sienta logo on the side moldings of the new Sienta using strong double-sided tape. There are many aftermarket products with Roman alphabet logos, but most of them are just stickers made with cutting sheets... This product uses acrylic resin, so you don't have to worry about air bubbles getting trapped underneath like with cutting sheets! Page 2 shows an actual installation image. Note: The installation image is a different color than the product being sold! Installation: Strong double-sided tape is applied to the back of the Roman alphabet plate. Installation is easy, just fit it into the logo area under the side molding of the car. It is important to thoroughly wipe off any dirt from the installation area before installing! On my own car, I installed it in February 2023, and I haven't had any problems such as it falling off or being damaged! Please understand that these are custom-made products, and only purchase if you agree. There may be some blackening on the edges due to laser processing, and slight unevenness in the cut-out areas of the letters. I am not accepting price negotiations for this product! m(__)m Also, I am not responsible for any damage to your car caused by the installation of this product. m(_ _)m