※ This is a set of 2. [This product is made to order] Scheduled delivery: Scheduled to ship on 10/24 ※ Shipping may be slightly delayed. [Item Name] Motor Stand with Heat Sink A motor stand for breaking in mini 4WD motors (both-shaft and single-shaft). [Material] Heat-resistant ABS [Size] Width 37mm x Depth 28mm x Height 35mm [Contents] Holder with heat sink (3D printed) 2 copper terminals Aluminum anodized heat sink [Features] ・It is possible to set the motor with a heat sink to suppress heat generation during motor break-in, etc. ・Ventilation holes are also provided on the back side. ・Can be used horizontally or vertically ・The shaft part is open, making it easy to apply bearing oil. ・Space-saving compact design ・Can be attached from the front side. ※ Removal is recommended from the top. ※ When using on the floor, customize with sponge brakes, etc., on the back. ※ Fixing with a vise is also recommended. [Notes] ・The motor shown in the photo is not included. ・Layering marks and scratches unique to 3D printers may occur. ・The motor holder and heat sink are new, but please understand that there may be minor scratches or dirt if they do not affect use. ・Copper terminals are prone to oxidation. There may be discoloration upon delivery, but please understand. Also, because they are cut to the specified dimensions, there are irregularities on the cut surfaces. Please understand that they will be installed after only minimal deburring. ・Since it is 3D printed, looseness may occur in the mounting depending on the number of uses. ※ The holder part will be sold separately as a consumable item at a later date. ・If there is a contact failure, install the motor with the terminals on the motor side slightly raised. ※ Shipping is in simple packaging to reduce shipping costs.