⚠️Important Notes⚠️ 1. The MS-50G+ unit shown in the images is not included in the package contents. 2. Due to the nature of 3D printing, there may be dimensional errors, variations in design, burrs, layer lines, stringing, and support material residue. 3. Do not apply excessive force to the product, as it may cause damage or injury. ---------------------------------- Product Description: This is a scroll plate & footswitch hat set for the following ZOOM products: * MULTISTOMP MS-50G+ * MULTISTOMP MS-60B+ * MULTISTOMP MS-70CDR+ * MULTISTOMP MS-200D+ Based on customer feedback, the footswitch hat has been changed to be 5mm thicker than the previous version (see image 8, the footswitch hat on the left). I made this with a 3D printer because I wanted to make the unit's cursor keys and footswitch easier to step on. As shown in image 1, the arrow parts are made of a glow-in-the-dark material. It glows after being exposed to strong light, but the glow doesn't last very long, so please consider it a bonus. ---------------------------------- Installation Instructions: 1. Attach the footswitch hat to the unit's footswitch. 2. Refer to image 6 and apply the included acrylic double-sided tape to the 4 cursor keys on the unit. 3. Remove the film from the top of the acrylic double-sided tape (it may be a little difficult to peel off, please understand), and attach the left and right scroll plates in a balanced manner (see image 2). Note: The acrylic double-sided tape is designed to peel off cleanly without leaving adhesive residue. ---------------------------------- Package Contents: 【Footswitch Hat】 x 1 (Silk Silver color) 　　　　　　　　【Cursor Key Buttons】 Left and Right, x 1 each 　　　　　　　　【Acrylic Double-Sided Tape (4 pieces)】 x 1 (See image 7) Scroll Plate and Footswitch Hat Material: 3D printer filament (PLA+)