I am customizing a 3D-printed puppy cotton candy doll purchased secondhand. *This is the 3D-printed version, not the resin cast version.* The doll is about 17cm tall overall, a size smaller than the larger resin version of the puppy cotton candy. I used a SDM-sized wig for the head. The body makeup was done by the previous owner, and the paw pads are pink. As shown in the 7th photo, there are some white scuff marks where the arms and torso, and the torso and legs connect. The photos were taken in a darker setting to make the scuff marks more visible. Please be aware of this before considering a purchase. The head makeup was done by me. I applied a coating agent and used acrylic paints, pastels, and silver ink for the makeup customization. I've also applied a little bit of pearl powder on the cheeks, which is fine and not very noticeable. I applied a coating agent at each stage to fix the makeup, but the makeup may rub off with strong friction. *This is amateur hobby makeup customization, so there may be asymmetry or some imperfections.* What is included: ・Customized body (including head, body, and eyes) ・Bonus wig *The outfits in the 8th and 9th photos are for reference only and are not included.* *The clothes are for a 10cm plushie, but the hip area is quite tight, and I'm putting them on with the back slightly open. Depending on the shape of the clothes, it may be possible to wear them as is.* The wig is an SDM-sized wig that I arranged, but the arrangement is quite rough, so please consider it as a bonus. #PuppyCottonCandy #BJD