Made by Mitsubishi Chemical OT Tour i80S This is a carbon shaft for iron with grip. It was assembled new in November 2024 and removed immediately after using it twice for practice, so both the shaft and grip are new and in very good condition. However, there is a slight fuzziness on the surface of the grip. The club length as stated on the workshop's specification sheet was 37.625 inches (60° method). The length will vary depending on the head specifications and insertion depth, so please consider that as a reference. Please check the second photo for the actual measured length. The shaft number is #6. This is a high-performance product adjusted for my own use. Please note that the shaft print is not facing forward due to spine alignment. If you align the grip logo to the front, the shaft spine position will be where it was adjusted. The spine alignment method is center-of-gravity insertion, and this method has the following effects: ・The shaft runs smoothly ・Head speed increases ・Improved grip ・The shaft moves the same way every time and doesn't wobble In particular, if you waggle or move it slightly sideways, the clubs with spine alignment using this method show a beautiful reverse flex of the shaft. This doesn't happen if no adjustments are made, so that's the difference, I think. The grip is: Elite Y360SH MB No Backline Approximately 50g / 60 caliber This is a high-performance grip that I use for all clubs except the putter. It was assembled by a top-class craftsman, so I think the performance is good and the finish is neat and beautiful. The tip is carefully protected by that craftsman. This shaft and the installed grip are definitely genuine. No returns or exchanges, please. Shipping is included, and since it's a long item, the shipping cost is not cheap, and fees will be deducted from here, so the price cannot be lowered any further, but we will offer a small discount (1000 yen per additional item) for bulk purchases. Please take advantage of this.