Thank you for viewing! This is a newly released product. This product is a bracket (mounting mount) for attaching the SwitchBot Hub 2 to a wall using a power outlet. It was designed for home use. By utilizing the mounting of a general Panasonic Cosmo series outlet, it can be installed with just a Phillips head screwdriver. It is especially recommended for those who do not want to make holes in their wallpaper. It is the thinnest design among the outlet-mounted mounts on the market, allowing it to adhere closely to the wall. By using a commercially available single-port L-shaped USB power adapter, you can install the SwitchBot Hub 2 more neatly. Please note that installation has not been confirmed on anything other than the Cosmo Series Wide 21 vertical two-outlet type. Also, processing is required for outlets with grounding. (Can be cut with scissors) - Set Contents: Cover (bracket), Case ※ SwitchBot Hub body and L-shaped tap are not included. - Weight: Approximately 120g - Material: Biomass plastic ※Caution ・Because it is designed to be as thin as possible, it is necessary to push the wiring into the cover. It's a little difficult, but it looks very neat when installed, so please understand. ・This product is made by a 3D modeling machine. There are no problems in use, but it will not have the strength and finish of a general injection-molded industrial product. Some unevenness and layering marks may occur. ・It softens at 60 degrees Celsius or higher. Use in direct sunlight or in a place with high temperatures is not recommended. ・Depending on the building's structure, the humidity near the outlet may be displayed high. Holder Mount Mounting bracket Bracket