Thank you for viewing! (o´∀｀o) This item is a name sticker (right side) with a slight sun-fading mark on the opposite side (left side) m(_ _)m Due to the slight reddish tint, I'm offering it at a discounted price! (^^) I apologize that it was difficult to capture in the photos (last one), making it hard to see. When viewed with the naked eye, you can tell it's "slightly reddish," but this perception varies from person to person, so please consider it as a reference...Σ(´∀｀；) It's a shoulder type, so you can use it in various ways (∩´∀｀)∩ I've attached lining to all of them ⭐️ However, if it becomes too thick, it's difficult to sew, and there's a possibility of breaking the sewing machine, so I used a thin fabric (^ー^) Shoulder types are particularly difficult to sew, and there may be slippage or distortion. Please understand that this is a handmade item by an amateur (;＞_＜;) For the part that goes over the chair, I used "quilted" fabric only for this part because the thin fabric is a little less durable (o´∀｀o) I've also attached a name sticker (^ー^) What's difficult about preparing for kindergarten or elementary school... Writing names... (^-^; You'll need to have the name written on it, but you can use it right away ( ´ー`) Since the name sticker is sewn all the way around, it shouldn't come off easily in the wash (^ー^) Because it's a plain name sticker, it's not overly noticeable (^ー^) You're unlikely to find anyone else with the same one! I've attached two Velcro fasteners to the part where you put in and take out the disaster prevention hood (^ー^) These are attached in a cross shape, so you don't need to check the location of the Velcro fasteners when attaching them, making it easy ( ´ー`) → See photo 7 Depending on the disaster prevention hood, the thickness or size may vary, but by attaching the Velcro fasteners in a cross shape, it should be somewhat flexible ( ´ー`) I've also attached Velcro fasteners to the part that goes over the chair (^ー^) These are attached horizontally (^ー^) (See photo 8) I made them horizontal to prevent them from slipping ⭐ Size is as follows↓ Approximately 35 cm long x approximately 50 cm wide Because I'm an amateur, there may be: Slippage Distortion Asymmetry etc. Even so, I've made it this way, without decorations, and carefully considering the construction, so that you can use it for as long as possible. 223