【Plate not included.】 This is a Telecaster assembly. Recommended for those who want to upgrade their current Telecaster. Assembly Introduction 【Pots】 Entry-level guitars often have metric-sized holes in their plates. I considered CTS pots, which are known for their quality, but CTS pots are inch-sized and not compatible. Therefore, I chose Alpha pots, which are metric-sized and excellent. You can install them directly onto your plate. I've made them full-size pots this time. They are 250kΩ, which is a good match for single-coil pickups. 【Jack】 I'm using a Japanese-made jack. The quality is quite good, and I feel it's not much different from Switchcraft. 【Wiring】 The wiring is cross-wire, which is also used in Fender and other high-end guitars. It's quite stiff and sturdy, so you don't have to worry about durability. ※The cross-wire will be either skin-colored or yellow. It's usually skin-colored, but it may be yellow sometimes. Please understand that there is no change in functionality. 【Capacitor】 The capacitor is the classic Orange Drop. Specs → 200v 0.047μf 【Switch】 A reliable ALPHA 3-way switch. As you can see, I've put a lot of care into the quality. All parts are brand new. I've grounded all the pots to reduce noise, so there's very little noise. Please feel free to upgrade. See the 345th image for wiring and pot dimensions. ※Please make sure that the distance between the screw holes under the plate and the pot holes is 1.5cm. If it's less than 1.5cm, the pots may not fit. Power-on confirmed. Shipping will be via Yu-Yu Mercari Mail A4 size. If you are worried about wire breakage, I can send it via Yu-Yu Mercari Mail Yu-Packet Plus for an additional 200 yen. I've already kept the price down, so I can't lower it any further. #Telecaster