Made by Fujikura Speeder TR Hybrid 75S This is a carbon shaft for utility clubs. This is a high-performance item that I adjusted for my own use. It was assembled new and removed after only one practice session, so the condition is very good. The specifications listed on the spec sheet when it was part of a club were: Length → 40.625 inches (60° method) Frequency → 282 cpm Tip Cut → 1 inch Please check the actual measured length in the third photo. The grip is: Elite Y360SH MB, no backline Approximately 50g / 60 caliber Please see the image for the specifications of the shaft itself when it was sold. Please note that the shaft print is not facing forward due to spine alignment. If you align the grip logo to the front, the position of the shaft spine will be where it was adjusted. The spine alignment method is weight insertion, and the effects of this method are: ・The shaft runs smoothly ・Head speed increases ・Improved grip ・The shaft moves the same way every time and doesn't wobble In particular, if you waggle or move it slightly sideways, the clubs with spine alignment using this method will show a beautiful reverse flex of the shaft. This is not the case if no adjustments are made, so that's the difference, I think. It was assembled by a top-class craftsman, so the performance is good and the finish is neat and beautiful. The tip is carefully protected by the craftsman. This shaft and the grip attached to it are definitely genuine. No returns or exchanges. Shipping is included, and since it's a long item, the shipping cost is not cheap, and fees will be deducted from this price, so I can't lower the price any further, but I will offer a small discount (1000 yen per additional item) for bulk purchases. Please consider it.