This is a dedicated case for adding tenting to the self-made keyboard "Corne Chocolate v4". This is for those who want to angle their keyboard or who have purchased only the PCB. 【Product Features】 ・Tenting legs can be attached and detached with magnets. ・Measured from the official Corne PCB data for a perfect fit. ・Rubber feet are already attached to the case body, allowing use even without angle adjustment legs. ・The printing environment has been improved, and the back surface has a textured finish like a grain. ・Compatible with Corne Chocolate v4. ・Made with a Bambu Lab 3D printer. 【Included Items】 ・Case body (left and right) x 1 each ・Tenting legs x 2 ・Rubber feet (already attached to the body) 【Installation Instructions】 Remove the bottom plate (PCB or acrylic) of the Corne and secure this case with the existing screws. 【Important Notes】 ・The magnets are fixed with press-fitting and adhesive. When removing them, slide them sideways instead of pulling them off forcefully. ・Due to being a 3D printed product, layer lines may be visible. Please be aware of this. 【Color Options】 Currently, "black" is the basic color, but "white" is also available. If you would like white, please contact us in the comments before or after your purchase. ※If there is no contact, "black" will be sent. Thank you very much for reading to the end. We sincerely look forward to your purchase. ※The original keyboard design is by foostan. Copyright (c) 2023 foostan Released under the MIT license https://github.com/foostan/crkbd