# Incubator, Cage Door opening: Approximately 270 x 270 mm External dimensions: Approximately 310 x 330 x h420 mm 100V specification, 150W heater. Temperature error: ±2°C Device to maintain a constant temperature Material: 5mm thick PVC board Frame: Steel square pipe Temperature setting range: Room temperature to approximately 42°C Please set the temperature up to around 42°C due to material limitations. This can be used as a cage for small animals that are sensitive to cold, reptiles, etc., and also as an incubator. It is very convenient as you can raise chicks inside the container until their feathers are fully grown. Please perform the egg-turning manually. Humidity can be maintained at around 60% simply by placing a container of water inside the container. Please understand that this is handmade, so there may be some scratches and dirt. Also, we cannot be held responsible for any accidents, so please purchase at your own risk. We also offer after-sales service. We will repair it free of charge, excluding shipping and parts failure, so please purchase with confidence. 【Regarding Future Production】 The most expensive temperature controller parts are out of stock. In the future, they will need to be purchased separately, making it difficult to list them for around 10,000 yen. The parts cost for this product is approximately 49,000 yen at retail price. I have been searching for new, unused items on auctions and Mercari, but there is a limit to the price, and there are also parts that can only be obtained by purchasing them online or at home centers. I am making it as a hobby, so I am not charging for processing fees at the moment. If the customer prepares all the parts, I can make it for around 5,000 yen. Parts List Temperature controller, solid state relay, pool box x 3, PVC board 300 x 300 x 5t x 4 sheets Terminal block, AC fan, heater, toggle switch, pilot lamp, thermocouple, hinge, door handle, door lock hardware, PVC pipe, wiring, outlet, steel square pipe, rubber feet x 4, other parts