Thank you for viewing. Manufacturer: koetsu Model: WING 6.0 I was curious about the quality and performance of the recent Chinese-made wing, so I purchased it this November. https://a.aliexpress.com/_c3y0Y2Ln The product is built similarly to famous brands like Ozone and GONG, and seems sturdy. Also, I felt that its performance, such as power and climbing angle, was comparable to that of the manufacturer's products. I have only used it twice for a very short time for testing, so there is no fading or tearing, and it is clean. I am selling it because the size overlaps with my other Wings. Although it is in a clean condition visually, please understand that it is a used product made in China and that it is sold as-is, no returns or exchanges. It is a type with booms at the front and rear, making jibes and tacks easier. In addition, there were some areas where the construction was slightly lacking, so I have made the following modifications: ① The sharp rivet heads holding the boom (25mm diameter carbon pipe) at both ends were exposed, and especially the front end of the front boom is a place that is constantly gripped and dangerous, so I changed only the front boom to button bolt fasteners with round heads. ② The rivet heads of the rear boom were wrapped with vinyl tape to prevent direct contact with the hands. ③ Non-slip grips were glued to the front and rear booms. Image: 16 ④ I wrote alignment marks on the valves of the leading edge and center strut for positioning the direction of rotation (for correcting the twisting of the inner tube). ~ Although there were ring nuts to prevent the rotation of both valves, they were loose, so I tightened them in the correct position. Image: 14, 15 ・The valves for injecting air are large Boston valves, the same as those used by Ozone and Starboard. ・The storage case, air pump, and leash cord are not included as I will use them for other purposes. Please consider this product on a no-claims, no-returns basis after understanding the above points. #foil #WingFoil #Foil #wingfoil