3D-printed screw-on holds. A new release from Ballers Half. The spherical crimp on the left side inspires setting. It's quite positive when used as is, so it's useful for problems with large, overhanging moves, undercuts, and side pulls. Combining two creates a pocket-like hold. It will be the core of the problem if used on a vertical or slightly overhanging wall. Also, there are mirrored versions, so if you want the right-side crimp, please let us know when purchasing. Friction processed. Made of PLA Recommended angle: 80-140° 3D-printed holds are hard and light, so they are durable. They will soften at 100°C or higher. I think it's not a problem in normal use, but please be careful in a car in summer. Also, if you overtighten with impact, the area around the screw hole may weaken due to friction heat. Please be careful not to overtighten. #bouldering #climbing #training #holdtraining #catchtraining #holds