Universal High Mount Battery Holder for 1/10 (3D Printer, PLA) The prototype base vehicle uses the upper deck mounting holes of the RD1.0. The (vertical side) can be used on chassis other than the YD series if the hole pitch matches. The (horizontal side) has elongated holes. It can be mounted on a wide range of chassis. Included: Battery holder body, 2 stopper plates (Please prepare set screws, collars, and lock nuts separately.) The design has been slightly changed (image 3). This will be applied to future orders. (Dimensions) Width: Approximately 98mm Length: Approximately 52mm Height: Approximately 29.5mm (including stopper plates) There may be layer lines and burrs characteristic of 3D printing. If you are concerned, please smooth them with sandpaper or putty. Please ask if you have any questions. # RD1.0 # YD-2 # YOKOMO Type...Radio Control Car