Thank you for viewing. This was installed as an upgrade for a Squier I owned. Power-on and operation have been confirmed. - Capacitor type: SANGAMO TYPE-33 - Potentiometer type: Alpha 250kΩ A-curve, metric size Pickup selector: musiclily ultra 5-way Some of the wiring uses LENZ wire [the yellow wire at the top of the selector]. The pickups were purchased from a handmade maker on Mercari. --Details and explanation below-- These are Stratocaster pickups completely handmade and hand-wound in Japan, from bobbin cutting to wiring. These are not rewound or modified cheap pickups. Cheap parts sold on AliExpress or in Akihabara are not used. The appearance and sound were reproduced as closely as possible by measuring vintage pickups. The mounting screw holes are the same inch size (6-32) as Fender USA. ALNICO3 Short G Staggered North Top (Center Non Reverse) Vulcanized fiber Bobbin Pole piece spacing: 10.42mm AWG42 Heavy Formvar Potting: Lacquer + beeswax, paraffin Pole piece insulation: Lacquer Front: Approximately 5.4kΩ Center: Approximately 5.4kΩ Rear: Approximately 6.0kΩ -------------------- The pickguard is a bonus. It is attached for storing the circuit. Screws to attach the pickguard to the body are not included. In my subjective opinion, when I installed it on a Squier, the sound resolution and richness improved due to the upgraded parts, and it was more comfortable to play. I felt a good balance because of the Alnico 3. The parts alone cost approximately 18,000 yen in total. - Soldering is done by an amateur, so please refrain from purchasing if you are looking for perfection. - The jack and the wiring from the jack to the volume pot are not included. Also, please install the solder connections and ground wire connections yourself. Please understand that this is a used item, and only those who can accept this are welcome to purchase.