This is a front rest that can be set on a piton shaft. It supports piton shafts up to 16mm in diameter. By rounding the part that contacts the rod, the rod is supported by the surface without the corners hitting, regardless of the angle at which the rod is set. In addition, it always supports the rod by the surface even when the rod is strongly pulled down and the rod bends significantly, preventing breakage. It is light and compact, so it won't get in the way even if you put it in your tackle bag. Manufacturer: FMW Material: Super duralumin ■About the material Made of super duralumin, a lightweight, high-strength material also used in aircraft. The specific gravity is only 2.8g/cm3, which is less than half of stainless steel's 7.93g/cm3, making it lightweight. Furthermore, the tensile strength is about 570N/mm2 for super duralumin, which is higher than stainless steel's approximately 520N/mm2. Each item is produced by cutting from the material, so the cost is inevitably high, but there are no welding points, which reduces the risk of breakage. → #Other FMW products are here [Ishidai, Japanese striped knifejaw, Ara, Longtooth grouper fishing, piton, rod butt, rod rest, leaf spring, bottom fishing, bottom fishing, Taman, Giant trevally GT]