The product is a set of an acrylic plate (as shown in image 2) and one punch tool. Upon arrival, please attach the acrylic plate and the seat using the included adhesive tape. If the adhesive tape does not hold, please be sure to read the following usage instructions. ◾️Product Description◾️ ⚫️Punch Tool (1 finished piece) Seat: 4 cm x 4 cm Height: Approximately 8.0 cm ※May be 2.3mm shorter. ○Circle diameter: 8 mm ⚫️Acrylic Plate 5 cm x 5 cm 3 mm thick acrylic plate As shown in the image ※The acrylic plate is transparent. Please peel off the protective seal before use. ※Please note that the acrylic plate may have some minor scratches. ⚫️Bonus Adhesive Tape ※Approximately 8 cm long ◾️Features◾️ A convenient tool for cutting dies, stamping, etc. When used in leathercraft, it can be used with a hand press machine to press into the leather for stamping or punching. When using with a drill chuck, the circle has a major axis of 8 mm, so please use a 13 mm chuck. ★Usage Notes (Images 6 and 7) The smooth molded plate surface of the seat is where you attach a metal cushion seal to the punch tool to prevent scratching the surface of the punch tool (the part you push) that you purchased yourself. If you press the deformed die (③), it will get scratched. ② The flat die is less likely to scratch the seat, but for a large flat die, it is easier to use if the seat is made larger. ※When using the press, if you are pressing something larger than the seat, or if the die design deforms the seat, place an acrylic plate or iron plate in between (sandwich) and enlarge the seat. ★If you don't mind scratches on the seat, please refer to this as a reference. Type: Hardware/Connecting Parts Uses: Leathercraft