Thank you for viewing! Feel free to ask any questions in the comments. Negotiations for price reductions are not accepted. Thank you for your understanding. This phone holder supports phones up to 18mm thick. The image shows an iPhone XR with an iFace case and a phone ring attached. (iPhone 15, 16 with iFace + phone ring also worked without issue.) It can be used while charging in either vertical or horizontal orientation. This smartphone holder uses a slide rail system that supports both vertical and horizontal placement to fit various phone sizes. The holder part is designed to be replaceable, allowing for long-term use. Spare holder parts are available separately if needed. 1. Rail + Holder (Basic Set) … ¥1,900 2. Basic Set + 1 Spare Holder … ¥2,200 3. Spare Holder Only … ¥500 ※ Purchasing the spare holder set (2) is ¥200 cheaper than buying the spare holder (3) individually. ※ Please note that this is the page for item 1. Made of ABS resin, it will not deform even in a car in the summer heat. This product is made with a 3D printer. There may be layer lines or some unevenness, but this does not affect use. ⭐︎Color⭐︎ Black (Material: ABS resin) Heat resistance is up to approximately 80°C. ⭐︎Dimensions⭐︎ Internal dimensions: Max width approx. 164mm, Depth approx. 18mm ⭐︎Shipping Method⭐︎ It will be wrapped in bubble wrap and shipped via Yu-Packet Post Mini. To prevent damage during shipping, the rail and holder parts will be separated and wrapped. Please assemble it yourself upon receipt. If the order falls on a weekend, shipping may be delayed until the following week. #3Dprinter #DelicaMini #Mitsubishi #SmartphoneHolder #SmartphoneStand #DedicatedDesign