Replacement parts (left and right set) for the legs (tilt stands) of the Thinkpad Trackpoint Keyboard Ⅱ if they are damaged. I designed and manufactured these myself using a 3D printer, and I am now selling them. 1 pair: 700 yen 2 pairs: 1000 yen ← Recommended 3 pairs: 1300 yen Please understand the following before purchasing: 1) Regarding damage and wear: While design improvements over four years have been implemented to prevent breakage, the material is plastic, so it will wear and break like the original. 2) Finish: Due to the nature of 3D printing, the surface will have patterns as shown in the photos. Please do not be concerned about the appearance as there may be variations in the finish. 3) Compatibility with the keyboard: Since I make these to fit my own keyboard, there is a possibility that they may not fit depending on the manufacturer's production date, etc. 4) Please replace both left and right sides at the same time. The height is not matched to the original product. 5) Discounts: There are no plans for discounts. 6) Notes on installation: ・The most common cause of damage is improper installation. Please be careful as incorrect installation, as shown in the photos, will immediately cause breakage. ・When installing, if you force it in from above, the shaft may break, so please install it carefully. ・Removal and reattachment are prone to damage and will shorten the lifespan. Before delivery, I will check the finish with a magnifying glass and test the installation on my own keyboard before sending it.