(JP¥1,700)
+NT$1,616 Shipping fee
+NT$64 Agent service fee
Text are automatically translated.
Report translation issueText are automatically translated.
Report translation issueFraud prevention
Customer support
Refund support for customers
Seller info
Nob
5/51399
View detail
Item condition
Brand New
Ships from
Japan
Category
Something went wrong, please try again later.
This item can't be bundled due to shipping restrictions. Please buy separately.
Something went wrong, please try again later.
This item can't be bundled due to shipping restrictions. Please buy separately.
Set of 6, 2x4 Adjusters With scratch-prevention sheets These are DIY parts for erecting pillars by fixing 2x4 lumber to the top and bottom. You don't need complicated procedures or special tools just to set up the pillars. You can easily install them because they can be firmly fixed using the force of a jack. Easy to create cat walks, wall storage Imitation and plagiarism are prohibited. Adjusters with only upper parts have existed before, but I thought about how to help those who don't have a drill or an 8mm drill, so I created the lower parts. I came up with the drill-free type. DIY Storage Parts I added a washer between the upper hexagon and the lumber. This addition stabilizes and prevents loosening. Therefore, when assembling the upper part, insert the washer into the bolt and then insert it into the hole. Assembly Since they are shipped disassembled, insert the washer into the bolt as shown in photo 3 and lightly tighten it (do not overtighten), then insert it, and put the washer, nut, nut, and washer in order, and tighten the upper part with a nut. Installation method ① Cut the 2x4 to be the pillar at a height of approximately 80mm less than the installation location. ② Screw the lower part of the adjuster to the top of the 2x4 cut in ①. (Photo 4) ③ Insert the screw side of the upper adjuster into the hole of the pillar made in ②. ④ Once you have adjusted it to the installation location, stand it vertically (level), and you can tighten it by turning the lower nut clockwise with a wrench. 〇 Place the scratch-prevention sheet between the floor and ceiling under the pillar and on the adjuster. It's easy to attach with double-sided tape. Required tools 〇 13mm wrench or monkey wrench, etc., a tool that can turn the nut 〇 Electric drill or impact driver or Phillips screwdriver 〇 Saw (can be cut at a home center) 〇 Level (there are also apps.) Drill not required Due to being handmade, there may be some variations. Painting is also possible, so please contact me. Any number of sets is possible. Please contact me. #Adjuster #CatTower #CatWalk #WallMountedTV #TensionWallStorage #Partition #FallPrevention #EscapePreventionFence
5 days ago