This is a tool to support the creation of handmade models. It makes it easier to sand down uneven surfaces and hard-to-reach areas during surface treatment and processing in model making. [Body] A 1mm thick plastic plate cut into approximately 5mm x 5mm squares is glued to one end of a φ3mm x approximately 90mm bamboo skewer at approximately 45 degrees. [Sandpaper] Waterproof sandpaper is attached with double-sided tape and cut to approximately 5mm x 5mm. Contents Body stick: 1 Waterproof sandpaper: #2000, approximately 5mm x 5mm, 5 sheets Waterproof sandpaper: #1500, approximately 5mm x 5mm, 5 sheets Waterproof sandpaper: #1000, approximately 5mm x 5mm, 5 sheets Waterproof sandpaper: #800, approximately 5mm x 5mm, 5 sheets Waterproof sandpaper: #400, approximately 5mm x 5mm, 5 sheets Waterproof sandpaper: #180, approximately 5mm x 5mm, 5 sheets ★Please Note★ ・Returns, refunds, and claims are not accepted after purchase. ・Since water-soluble adhesive is used in the production of the body, when using it for wet sanding, apply water only to the sandpaper. ・Because this is a handmade item by an amateur, there may be dimensional errors, positional deviations, etc. Thank you for viewing. #PlasticModel #Model #Production #Tool #Handcraft #Modeling #Molding #Details #Gunpla #CarModel