This is an original part designed by us. It allows you to connect the lead car (powered car) and the trailing car of Plarail trains, which is not normally possible. [Important] This product is mainly for trains with short front ends, such as conventional lines. Please check the compatible vehicle types below. Compatible Vehicle Types: ・The distance from the screw position on the back of the lead car to the front of the vehicle is less than 1.5cm. ・The screw position on the back of the lead car is in the center of the vehicle's width. [Features] ・Easy installation with screws ・Secure connection with neodymium magnets ・Safe for young children (even 2 and 4 year olds can play with it without any problems) ・Can run on winding curves and sloped curves ・Multiple units can be used to connect several Plarail trains [Installation Tip] When removing the existing screws from the lead car, it is easier to remove them by pressing them in the direction of removal while turning. [Note] Only the connecting parts (including the mounting screws) are sold. Vehicles are not included. Contains small parts, so please give them to young children after installation. [Other] Plastic parts are created using the latest 3D printers. Due to the nature of 3D printing, there may be variations in quality, but in most cases, there are no problems with functionality or durability. If there is an initial defect in the product, we will accept an exchange, so please contact us. We also sell parts for trains with long front ends (1.5~2.6cm), such as Shinkansen. By using both, you can connect conventional lines and Shinkansen trains. Type...Vehicle Parts For Plarail Lead Car (Powered Car) & Trailing Car Connecting Parts Magnetic Connection Special Connection Coupler Front Rear Front and Rear Connection Magnet Attachment Parts