# My Auction I'm selling this off cheap because I don't use it anymore. The headstock shape might be a matter of preference, but I think it's unique with its elaborate tapered cut. The included tuners are the so-called "turtle" type, but the home plate-shaped ones don't look too bad. It might not be necessary for those who are component-building, but I've included a plastic nut (not glued). The fret life is probably around 70%. Frets 11 and 12 seem to have been replaced, but I've lightly leveled them to match the height. The rosewood fingerboard has also been lightly polished. The end width is 55.5mm and the height is 24mm, so it should fit a standard Strat body. The wood is a high-quality, tight-grained maple, which will produce a thick sound. Because of the tight grain, I haven't measured it, but I think it's a bit heavy. The shape is a C shape, not too thin. The paint on the back of the neck has been stripped to remove scratches. However, there are still some minor scratches, so please consider it with the assumption that it will need some repair. If you strip the paint from the matching headstock and add your own original logo, it would be a great-looking neck. For those looking for a good-quality neck for original component builds, this is much better than a neck made from cheap, plain-grained Chinese wood. The price is just a little more than the shipping cost, so why not give it a try? Thank you for looking. #StratNeck #JapanVintage #ComponentGuitar