※ Currently, the black dish with holes is out of stock and cannot be produced. ○ Contents ・ PP dish (black) with holes ・ Lid removal processing ・ Reverse-wear specification ① ・ Main / SH23mm ・ Rim side / R processing ・ Dummy / Red x Black x Red ・ Rib 22.5mm / R processing ・ Rim cut ・ Hexagonal through-hole, shaft centering processing ・ Adhesive with double-sided tape ・ Shaft removal with special tools even after processing ※ Wheels are selected after through-hole and hexagonal hole forming, those with shaft wobble are excluded. ・ Final finish, not just rough cutting -------------------------------------------------- ※ Notes ※ ⭕ We use a slightly smaller shaft bit than reinforced or hollow ones to fix the tires in the normal wear state and cut them! If you use them in reverse-wear specification, it will be the first insertion, so please check the surface of the shaft carefully before inserting. There is a possibility of shaft misalignment. ※ In the unlikely event that you insert it from the reverse side and wobbling occurs, we cannot be held responsible, so please understand. ⭕ These are handmade by an individual. Please understand that there may be slight differences in the finish. ⭕ Please refrain from returns, refunds, and claims after inserting the shaft after purchase, as this is a personal listing. ⭕ Please purchase after confirming the profile. -------------------------------------------------- 【About Orders】 ・ If you wish to order, please write the desired tire configuration as described above, and we can proceed smoothly to production m(_ _)m