MINOURA (ミノウラ) VERGO-TF2-WH Bicycle Car Mount This is a mount for carrying bicycles in a car. It can secure up to two bicycles. The current setup allows for one thru-axle and one quick-release bicycle to be secured. Images 5, 6, and 7 are used for illustration purposes, cited from the manufacturer's website. Used once, cleaned, and then stored. Will be shipped in the product box. The following three items are included in this sale: VERGO-TF2-WH: ¥19,800 ASB-10 Assist Bar: ¥3,300 12mm Thru-Axle Type Front Fixing Adapter: ¥660 Total: ¥23,760, but offered at ¥8,900. Thank you. The following information is from the manufacturer's website: Mainly for two bicycles, suitable for many kei cars (small Japanese cars) to ordinary passenger cars (wagons). Includes one wheel holder (for two wheels) The quick-release of VERGO-TF is a wide-open type with an original design. Convenient for attaching and detaching the front fork with lever operation only. Since there is a front fork receiver on the base rail, it is less likely to wobble compared to VERGO Excel (early series). The front fork receiver can be twisted to adjust the space between the bicycles so that the handlebars do not touch each other. The front fork receiver can be rotated 15 degrees/30 degrees to the left and right, and 90 degrees when using the TF stand, with the quick release parallel to the race as a reference. All options for VERGO Excel (early series) can be used. VERGO-TF Wheel Holder Features This is an arm to hold the wheels removed from the bicycle mounted on VERGO-TF. Two wheels can be attached to the tip of the arm and the through-hole at the top. The angle of the arm can be freely set, and stability is improved by adjusting it so that the tires touch the floor. If you remove both front and rear wheels, attaching the Rear End Support 3 (sold separately for VERGO) to the rear end of the bicycle will prevent oil from the chainring and contact of the gear teeth/rear derailleur with the floor.