This is a set that allows you to build an 8-shaped elevated crossing layout with Capsule Plarail. The slope uses 6 levels of bridge piers. The train smoothly circles and climbs the slope. A gutter bridge four times the length of a regular bridge is placed. It can run without problems even with a wind-up train. All parts are custom-made, but they can also be connected to genuine rails. Since they are longer than official rails, stable running can be expected. Set Contents Gutter bridge rail (green) x 1 2x length straight rail (male/female) x 4 1.5x length straight rail (male/female) x 2 1x length straight rail (male/female) x 1 45-degree double track curved rail (male/female) x 10 45-degree double track curved rail (male/male) x 1 45-degree double track curved rail (female/female) x 1 Various slope bridge piers x 10 Elevated bridge piers x 4 If you connect curved rails before and after the gutter bridge, the trains may collide. Please place them with straight rails in between. Unlike official rails, these rails can only be run on one side. Due to the unique sleeper design, they may not be compatible with some scenery parts. When testing various wind-up trains, some 3-car trains were unable to climb the slope. So far, there have been no problems with motorized trains. Also, adding weight to the drive wheel side of the wind-up train allowed it to climb the slope, suggesting that slippage is due to the lightness of the train. If you have any concerns, please refrain from purchasing. We apologize for the insufficient testing. *This product is a custom-made part produced by an individual using a 3D printer. Please be aware that there may be stripes, color differences, and rough surfaces due to manufacturing reasons. *The material used is PLA, a plant-derived plastic. It is prone to deformation at high temperatures, so please be careful. Thank you for viewing.