Set of 6 2x4 Adjusters with screws included.
Scratch-prevention sheets are an extra 100 yen. Please comment if you want them.
Up to 7 sets are available. Please comment for other quantities.
These are DIY parts for fixing 2x4 lumber to the top and bottom to create a pillar.
You don't need complicated procedures or special tools just to set up a pillar.
You can easily install them because they can be firmly fixed using the force of a jack.
Imitation and plagiarism are prohibited.
Adjusters with only the upper part have been available before, but I thought about how to help those who don't have a drill or an 8mm drill, so I created the lower part. I came up with the drill-free type.
DIY Storage Parts
A washer has been added between the upper hexagon and the lumber. This addition provides stability and prevents loosening.
Therefore, when assembling the upper part, insert the washer into the bolt and then insert it into the hole.
Assembly
Since they are shipped disassembled, insert the washer into the bolt as shown in photo 3 and lightly tighten it (don't overtighten), then insert it, and then insert the washer, nut, nut, and washer in that order, and tighten the upper part with a nut.
Installation Method
① Cut the 2x4 to be the pillar at a height of approximately 80mm less than the installation location.
② Screw the lower part of the adjuster to the top of the 2x4 cut in ① (photo 4).
③ Insert the screw side of the upper adjuster into the hole in the pillar made in ②.
④ Once you have aligned it with the installation location, stand it vertically (using a level), and you can tighten it by turning the lower nut clockwise with a wrench.
〇 Place the scratch-prevention sheet between the floor/ceiling and the bottom of the pillar and the top of the adjuster. It's easy to attach with double-sided tape.
Tools Required
〇 13mm wrench or monkey wrench, etc., a tool that can turn the nut
〇 Electric drill or impact driver or Phillips screwdriver
〇 Saw (can be cut at a home center)
〇 Level (there are also apps.)
Drill not required
Due to being handmade, there may be some variations.
Painting is also possible, so please contact me.
Any number of sets is possible. Please contact me.
Tension pet gate
Tension baby gate
#Adjuster
#CatTower
#CatWalk
#WallMountedTV
#TensionWallStorage
#Partition
#FallPrevention
#EscapePreventionFence