This is a FLASHFORGE Adventurer 3. Operation has been confirmed. The operating time is short, at 818 hours. It has been customized, so please see the details below. 【Customizations】 ① Replaced the normal nozzle with a genuine 0.4mm 265℃ nozzle (※See photo 12) → Supports high-temperature printing, allowing for printing of PLA/ABS/PETG, etc. ② Replacement of the right side cover (※See photo 7) → As the original cover was lost, a cover from another Adventurer 3 I own will be included. The cover has a hole for feeding filament from the outside. ③ Changed to a new air tube joint (※See photo 13) → Replaced with a new one. ④ Installed a deodorizing filter on the ceiling (※See photo 15) → Following this page, a deodorizing filter has been installed. (h ttps://kakeru-cobo.com/3dprinter-diy-free-3dmodel/) ※ It is attached with bolts and double-sided tape, so it can be easily removed if not needed. ※ The deodorizing filter was just replaced, so it should last for a while. 【Accessories other than the main unit】 ・Genuine normal nozzle (used) x 2 ・Pin tool for unclogging x 1 ・Screwdriver ・Power cable There are signs of sun damage on the main unit, and there is dirt and scratches on the glass surface, but because the operating time is short, it should still be able to perform well. Filament is not included, so please purchase it separately. How about this for beginners who want to start 3D printing or those who need a box-type 3D printer? The Adventure3 series has a large user base, and you can easily learn calibration and printing settings on YouTube. You can also download the manual from the following webpage, so I think it's a recommended model. (h ttps://after-support.flashforge.jp/manual/) As the original box cannot be found, it will be carefully packed in a box from another 3D printer and shipped.