※ The photos are reused because there is no significant difference in the finished product. ※ If you wish to purchase the PS3 Bryce (Photo 9) as a set, it can be added for an additional 500 yen (regular selling price 780 yen). I strongly recommend it, as it's easy to install during the disassembly and repair. Please refer to the listing page for details on the PS3 Bryce. ※ If you purchase two sets, you will receive the Bryce mentioned above as a free gift. This is a replacement board compatible with YLOD repair for the PS3 Tantalizer, developed by a famous overseas YouTuber. This is the latest version, "PS3 Tantalizer 0.9b". Official website: https://oshpark.com/profiles/RIP-Felix ・Designed to replace the NEC/TOKIN Proadrizers used in some PlayStation 3 models. It does not require you to cut the board or install it at an angle (difficult). Simply place the repair parts as shown in the photo and lightly solder the contact components. ・The board is equipped with 6 x 0805 size MLCC ceramic capacitors and 3 x 7343 size conductive polymer aluminum electrolytic capacitors in parallel. ・The 7343 capacitor must be 2.5V・470UF or higher. 　The configuration of 0805 MLCC is as follows: 　47UF / 22UF / 10UF / 4.7UF / 2.2UF / 1UF 　→ With the above combination, it demonstrates performance equal to or better than the original NEC/TOKIN Proadrizers. ・You can freely cut the grooved areas on the outside of the board. A pre-cut version is also available separately, so please consider that as well. ※ There is still stock available, so if you wish to purchase, please let me know the required quantity. ※ Due to manual implementation, the finish is not as clean as machine implementation, and there are some slightly misaligned parts, but there are no operational problems. The operation has been confirmed with a tester after completion.